Beam Size Calculator — IS 13920 Guidance
Preliminary geometry guide: D = L/12 to L/10, b ≈ D/1.5, and b ≥ minimum width. This calculator provides preliminary geometry and reinforcement visualization only.
Beam Cross-section (dynamic)
Results
Engineer notes
- This tool provides preliminary geometry and visualization; it does not replace a complete structural design.
- Approximate effective depth is calculated as d = D − (cover + stirrup dia + 0.5 × main bar dia).
- Full bending, shear, serviceability, anchorage, development length and ductile-detailing checks must be carried out separately.
- This visualization assumes a rectangular beam and does not design a T-beam flange.
Detailed Solved Example
The following example uses the same calculation logic as the interactive calculator. It is deliberately separated from the calculator so that the JavaScript cannot accidentally overwrite or depend on example-page elements.
1. Given data
Depth rule = Auto (mid of L/12 and L/10)
Width rule = D/1.5
Minimum width = 200 mm
Clear cover = 25 mm
Stirrup diameter = 8 mm
Main bar diameter = 16 mm
2. Step 1 — Convert span to millimetres
3. Step 2 — Preliminary depth range
4. Step 3 — Select overall depth
5. Step 4 — Calculate width
Since 367 mm > 200 mm minimum, no minimum-width correction is required.
6. Step 5 — Approximate effective depth
7. Step 6 — Rough deep-beam flag
8. Summary
| Parameter | Result |
|---|---|
| Clear span L | 6000 mm |
| Depth from L/12 | 500 mm |
| Depth from L/10 | 600 mm |
| Selected overall depth D | 550 mm |
| Calculated width D/1.5 | 366.67 mm |
| Rounded width b | 367 mm |
| Clear cover | 25 mm |
| Stirrup diameter | 8 mm |
| Main bar diameter used for d | 16 mm |
| Approximate effective depth d | 509 mm |
9. Important engineering limitation
10. Recommended engineering workflow
- Select preliminary beam dimensions.
- Determine dead and imposed loads.
- Establish support conditions and design load combinations.
- Calculate design bending moments and shear forces.
- Design longitudinal reinforcement.
- Check minimum/maximum reinforcement.
- Design shear reinforcement.
- Apply applicable ductile-detailing provisions.
- Check serviceability and constructability.
- Prepare the final reinforcement drawing only after all checks pass.
0 Comments
If you have any doubts, suggestions , corrections etc. let me know